Operation CHARM: Car repair manuals for everyone.

Chain and Disc Set I Assembly Overview






Chain and Disc Set I Assembly Overview

Part 1





1 ATF filter

• Different versions

• Removing and installing => [ ATF Filter ] Service and Repair

2 Bearing "D"

• Disc set roller bearing "I"

• Different version: With or without inner race

• Removing and installing => [ Bearings D and E for Disc Set I ] Bearings D and E for Disc Set I

3 Bearing "E"

• Disc set ball bearing "I"

• Removing and installing => [ Bearings D and E for Disc Set I ] Bearings D and E for Disc Set I

4 Intermediate housing

• Removing and installing => [ Chain and Disc Set I ] Chain and Disc Set I

5 Bolt

• Different designs and lengths depending on version

• Replace bolts.

• Steel bolt - 25 Nm

• Aluminum bolt - 10 Nm plus an additional 90° (1/ 4 turn)

6 Sensor wheel "II"

• Always replace after removal

• Removing and installing => [ Chain and Disc Set I ] Chain and Disc Set I

7 Oil pipe

• Do not damage sealing surface.

• Removing and installing => [ Chain and Disc Set I ] Chain and Disc Set I

8 Cover

• For sensor wheel "II"

9 Axial sealing element

• For ATF filter

• Replace

10 Sensor wheel "I"

• Always replace after removal

• Removing and installing => [ Chain and Disc Set I ] Chain and Disc Set I

11 Securing ring

• Replace

• After replacing disc set, "I" must be measured again => [ Determining shim and circlip ] Disc Set I

• Must contact the base of the groove

• Installation position: The bores in the eyes are conical. The narrow side point up

12 Adjustment shim

• After replacing disc set, "I" must be measured again => [ Determining shim and circlip ] Disc Set I

13 Oil pipe

14 Clip

• For oil pipe

15 O-Ring

• Replace

16 Securing ring

• For ball bearing and roller bearing

17 Bolt

• 10 Nm

Part 2





1 Transmission housing

• With disc set "II"

2 Alignment bushing

3 Gasket

• Replace

4 Disc set "II"

• Cannot be replaced separately

5 Alignment bushing

6 Suction jet pump

• Removing and installing => [ Suction Jet Pump ] Suction Jet Pump

7 Guide rail

• Clipped onto oil pipe - 10 -

• Install with chain mounted

8 O-Ring

• For oil pipe

• Replace

9 Bolt

• 10 Nm

10 Oil pipe

11 Oil guide piece "I"

12 Oil guide piece "II"

13 Thrust washer

• Identify with color

• Do not interchange with shim => [ (Item 12) Adjustment shim ]

14 Chain

• Removing and installing => [ Chain and Disc Set I ] Chain and Disc Set I

15 Disc set "I"

• Removing and installing => [ Chain and Disc Set I ] Chain and Disc Set I

• Replace => [ Disc Set I ] Disc Set I

• After replacing, circlip => [ (Item 11) Securing ring ] and shim => [ (Item 12) Adjustment shim ] must be measured again => [ Disc Set I ] Disc Set I

16 Securing ring

• For bearing "C"

17 Bearing "C"

• Disc set roller bearing "I"

• Removing and installing => [ Bearing C for Disc Set I ] Bearing C for Disc Set I

18 Oil pipe

• With rectangular ring

• Removing and installing => [ Disc Set I ] Disc Set I