Flywheel: Service and Repair
Replacing the dual mass flywheel
Special tools:
999 5112 GEAR SECTOR 999 5112 Gear Sector
999 5678 Special screw 999 5678 Special Screw
Preparatory work
- To remove the transmission from turbocharged engines, see Replacing the transmission, AW50-42 Replacing Transmission. For engine B4204S2,
- Remove clutch driven plate B4204S2,
Removing the flywheel
- Remove the engine speed (RPM) sensor assembly with the bracket.
- Slacken off the 10 screws for the flywheel crosswise. Lift out the flywheel.
- Check the rear oil seal on the crankshaft for leakage. Clean if necessary.
- Turbocharged engines: to replace the oil seal for the crankshaft, see Replacing rearmost crankshaft retaining ring Replacing Rearmost Crankshaft Retaining Ring.
- B4204S2 engines: to replace the oil seal for the crankshaft, see Crankshaft seal rear, replacing Crankshaft Seal Rear, Replacing.
Installing the flywheel
Use tool 999 5678 Special screw 999 5678 Special Screw , with 3 studs and nuts.
- Ensure that the crankshaft flange and flywheel mating surfaces are completely clean.
- Install the 3 studs as illustrated. Turn the short thread length towards the crankshaft.
- Install the flywheel.
Note! Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel. There is a marking to show the position of the guide hole.
- Align gear sector 999 5112 GEAR SECTOR 999 5112 Gear Sector.
- Pull the flywheel towards the crankshaft with the three nuts on special tool 999 5678 Special screw 999 5678 Special Screw.
- The turned section of the nut must be turned towards the flywheel.
Note! It is important that the flywheel bears on the crankshaft flange before the other screws are installed.
- Install the other screws. Use new screws. Tighten the screws crosswise to 45 Nm.
- Remove special tool 999 5678 Special screw 999 5678 Special Screw. Install three new screws. Tighten the screws to 45 Nm.
- Angle-tighten all the screws crosswise to 65 degrees.
- Install the engine speed (RPM) sensor assembly with the bracket. Tighten the screws to 10 Nm.
Reinstall the transmission
Note! To install the transmission on turbocharged engines, see Replacing the transmission, AW50-42 Replacing Transmission. For engine B4204S2, see Transmission, installing Transmission, Installing.
Test driving and checking
- Clean and check that everything is in position.
- Start the car. Check first with the gear in neutral.
- Rapidly depress and release the clutch a couple of times.
Then test drive car without putting any pressure on the clutch at first.
Once the engine has reached operating temperature and the clutch feels normal, try a few test starts with rapid gear changes.
There should be no jerking or vibrations.
Caution! Inform the customer that a new flywheel has been installed.