Removal and Replacement
Condenser
Replacing condenser
Special tools:
999 5474 RADIATOR PROTECTION 999 5474 Radiator Protection
Warning! Follow the appropriate safety precautions when working on the climate control system, see Refrigerant, safety regulations Refrigerant, Safety Regulations.
Note! Read the instructions about slow and large leaks, see Oil in the air conditioning (A/C) system Oil In The Air Conditioning (A/C) System.
Note! Always use new O-rings lubricated with air conditioning (A/C) compressor oil.
Note! Always plug pipes and connectors when working on the climate control system.
General
- Drain the refrigerant from the system, see Draining Draining.
Remove the pipe between the condenser and receiver drier
- Removing the pipe between the condenser and receiver drier, see Pipes and hoses Removal and Replacement.
Removing condenser
- Remove the upper support for the cooler
- Disconnect the pipe for the condenser from the cooler and plug the openings
- Remove two mounting screws from the condenser
- Lift up the radiator slightly and push it towards the cylinder block (press at the bottom of the radiator)
- Lift the condenser. Remove it with a twisting movement.
Installation
- Transfer the components (foam, rubber etc.) to the new condenser
- Position the condenser. Tighten to 10 Nm
- Install the radiator and secure it at the support. Tightening torque 10 Nm
- Remove the seals
- Lubricate the new O-rings with compressor oil
- Install the pipes. Tighten the pipes to 25 Nm.
Filling with refrigerant
- Vacuum pump according to Vacuum pumping Vacuum Pumping
- Fill the system with refrigerant according to Filling with refrigerant Filling With Refrigerant
- Fill the system with fluorescent tracing agent according to Filling with fluorescent tracing agent Filling With Fluorescent Tracing Agent
- Leak trace according to Leak tracing, electronic leak tracer Leak Tracing, Electronic Leak Tracer or Leak tracing with fluorescent tracing agent and an UV lamp Leak Tracing, Fluorescent Tracing Agent/UV Lamp.