Ignition System
Control function #2 tests the crankshaft position/speed and throttle position (idle switch) sensor signal.Entering Control Function #2:
TESTING PROCEDURE:
1. Turn ignition ON.
2. Open the diagnostic socket cover and connect the selector cable to pin #6.
3. Depress the button on the diagnostic socket twice.
Each time depress the button for at least 1 second but not more than 3 seconds.
4. The light diode should begin to flash rapidly. If light diode doesn't work at all, check the ignition ECU wiring and the diagnostic socket (see DIAGNOSTIC SOCKET under COMPONENT TESTING).
Code 1-4-1:
5. Crank starter.
6. The light diode should go out and start flashing code 1-4-1.
a. If so, engine speed sensor is O.K..
b. If light diode continues to flash rapidly, see Powertrain Management/Computers and Control Systems/Crankshaft Position Sensor/Testing and Inspection/Procedures under COMPONENT TESTING.
Code 3-3-4:
7. Check the throttle position sensor idle switch by opening the throttle valve (idle switch opens).
8. The light diode should go out, then flash code 3-3-4.
a. If so, throttle position sensor idle switch is O.K..
b. If light diode continues to flash rapidly, see THROTTLE POSITION SENSOR under COMPONENT TESTING.
9. Turn ignition OFF.
10. Remove selector cable and close the diagnostic socket.