Boost Solenoid: Testing and Inspection
TESTING PROCEDURE:NOTE: While trouble shooting, always check the wiring, fuses and connectors for good condition and routing. Also check ground locations for good connection. Use the wiring diagrams found in SCHEMATIC DIAGRAMS to supplement your testing efforts.
1. Turn ignition OFF.
2. Disconnect turbo boost ECU connector.
3. Connect a voltmeter between ECU connector pin 3 and ground.
4. Turn ignition ON.
Reading: approx. 12 volts
a. If reading is correct, turbo boost relay is operating correctly.
b. If reading is incorrect, check and repair wire (red) to relay. If wire is in good working order, proceed with next steps.
5. Disconnect turbo boost relay.
6. Check for voltage at relay terminal connector #1 (red wire).
Reading: approx. 12 volts
a. If reading is correct, turbo boost relay is receiving operating voltage.
b. If reading is incorrect, check/repair wire (red), fuse and battery connections. If no fault can be found, proceed with next steps.
7. Check for voltage at relay terminal connector #4 (blue wire).
Reading: approx. 12 volts
a. If reading is correct, turbo boost relay coil is receiving operating voltage.
b. If reading is incorrect, check/repair wire (blue) to ignition coil. If no fault can be found, check ignition circuit from battery through the ignition switch to the ignition coil terminal #15 (positive side). Repair as necessary.
8. Connect an ohmmeter between relay terminal connector #2 (black wire) and ground.
Reading: 0 ohm
If not, repair wire or connection to ground and retest.
9. Reinstall turbo boost relay.
10. Connect the voltmeter between ECU connector pin 3 and ground.
Reading: approx. 12 volts
a. If reading is correct, turbo boost relay is now operating correctly.
b. If reading is incorrect, replace and retest with new turbo boost relay.
11. Turn ignition OFF.
12. Disconnect all test equipment and reconnect ECU connector.