Operation CHARM: Car repair manuals for everyone.

Engine Control System - Fault Tracing


91volvo02

SECTION GROUP NO.

23 134

DATE JULY 1989
RE:

740 Series L.H. 2.4 Fault Tracing B230F 1989 M/Y MFK 30


THIS SERVICE BULLETIN APPLIES TO U.S. AND CANADIAN DEALERS


Reference: T/P 31354/1 L.H. 2.4 System 740 Series 1988 - 8......

Fault tracing the L.H. 2.4 System


The attached fault tracing flow chart is intended to assist in the repair of the L.H. 2.4 fuel management system.

The fault tracing chart and CO meter are useful tools when one or both of the fault codes for the CO adaptive system (2-3-1 or 2-3-2) are included as a fault code from the self diagnostic system.

Begin the fault tracing as follows: Return the adaptive system to an original condition by disconnecting the power to the fuel control unit, as shown in the fault tracing chart.

When the oxygen sensor is disconnected, CO should read a normal (0.5-1.5% stable) value for an open-loop condition, if the components that monitor the air/fuel mixture (for example, fuel control unit, air mass meter and temperature sensor) are functioning properly.






If the fault tracing chart indicates replacement of the oxygen sensor is necessary, this can be verified by measuring the output signal from the oxygen sensor to check for normal function fluctuations (as indicated on the LH or monotester). It is also important to check the preheating of the oxygen sensor function by measuring power supply and resistance according to the appropriate Service Manuals.


Please note that it is now recommended if a fault is discovered requiring replacement of the oxygen sensor, the O2 sensor should be relocated. To do so, the earlier version catalytic converter should also be replaced. (Limited to 1 replacement per vehicle). (see chart below).


The O2 sensor is now installed in the inlet flange of the catalytic converter in production. Vehicles manufactured after the Ch. No.'s listed below contain this later type O2 sensor and catalytic converter as original equipment, and will not require catalyst replacement.

When replacing the catalytic converter, the original oxygen sensor location in the exhaust pipe must be sealed with the plug and washer listed below.


This catalytic converter replacement applies to the following vehicles only:

M/Y Model Factory Code VIN MFK
1989 744 1 Up to & including 375190 30
1989 745 1 Up to & including 228825 30
1989 744 2 Up to & including 369790 30
1989 745 2 UP to & including 227961 30
1989 744 3 Up to & including 370535 30
1989 745 3 Up to & including 227705 30

Note: MFK 31 vehicles (California) are not included.

The following parts will be required:

P/N Description

3531401-2 Catalytic converter
960632-8 Plug
947624-3 Washer


Op. No. Description Time

259102 Catalytic Converter Replace 0.4 hr.
254413 Oxygen Sensor Replace 0.1 hr.