Selector Panel, Checking/Adjusting
Service check:
1. Engine should start only with gear selector in position P or N.
2. Reversing (back-up) light should be lighted when position R is selected.
3. Gear selector lever should be vertical in position
4. Gear selector play from position D to position N should be less than or equal play from position 3 to position 2.
Adjusting linkage:
Select position P
Slacken retaining nuts for connecting rod and lever
Check that lever on transmission is at position P (i.e. 1st notch as seen from rear)
Turn transmission output shaft until it locks.
Set lever in vertical position (or just barely tilted forward) and tighten retaining nut
(Gear selector can strike dashboard if lever is too far to rear)
Push connecting rod gently to rear until slight resistance is felt. Tighten retaining clip to approx. 5 N-m (3.5 ft.lbs.).
Adjusting play
Check that D-to-N play is less than or equal to 3-to-2 play.
If correct: tighten retaining nut (tightening torque 17-23 N-m = 12-16.5 ft.lbs)
If incorrect: adjust as follows:
If gear selector lever is stiff in position D:
- move connecting rod 2 mm (0.08 in) to rear
If gear selector lever is stiff in position 3:
- move connecting rod 3 mm (0.12 in) to front
Distance between two marks at rear of connecting rod mounting represents 2.5 mm (0.1 in). Tighten retaining nut (tightening torque 17-23 N-m = 12-16.5 ft.lbs.)
Check:
- Engine should start only with gear selector in position P or N.