Operation CHARM: Car repair manuals for everyone.

Blower Housing, Modification For New Spare Motor

CAUTION: Radio with microprocessor. To prevent damage to the radio microprocessor, the radio must be switched off before disconnecting the battery ground lead.

NOTE: When installing a new blower motor on earlier cars with all climate units, the blower housing must be modified to enable the new blower motor to be used.

Required Material:
Blower motor kit, Part Number 3537854-6, quantity 1.
Soundproofing panel, type 1 Part Number 3527931-4, quantity 1.

Modification:





1. Disconnect battery ground lead.





2. Remove soundproofing panel on passenger side.
3. Remove side panel on passenger side.





4. Disconnect control module connector.





5. Remove control module and mounting bracket.





6. Disconnect original blower motor and electrical connections
Remove blower motor gasket





7. Cut plastic tube flush with blower housing. Use hacksaw blade. File cut surface level to ensure best possible seal.





8. Install adapter ring. Prior to installation run bead of sealant as per (A) in illustration and plastic foam seal as per (B). Seal only mating face with blower housing.





NOTE: Ensure that locating pin on adapter ring is seated in heater housing. Mount ring using five countersunk screws (Torxscrew T2O), ensuring that gasket is correctly positioned.

9. Install adapter.





10. Cut 18 mm hole in heater housing with hole saw, using adapter ring as template. Clean off plastic chips.





11. Assemble blower motor, cover rubber gasket (A). Install foam rubber seal around drain pipe (B).





12. Install blower motor in heather housing. Tighten screws (three).





13. Install new connector:
- Cut cable terminals off existing wiring.
- Fit two cable terminals, Part Number 979003-1. Press cable terminals onto connector with (SB-W) connected to thinner lead (position 2).
- Connect wiring harness (A) between motor and wiring harness in car.
- Reconnect battery ground lead. Test operation.





14. Start blower motor. Use hand to feel around adapter ring for air leakage. If leakage is present, seal with butyl tape.
15. Install control module bracket.
16. Install control module and connector.
17. Install side panel.
18. Install new soundproofing panel.