Fuel Filter - Revised With Modified Nut Attachment
88volvo01Subject: Product
REPLACEMENT CARS
FUEL FILTER - FUEL INJECTED
ENGINES ONLY - Group
200 SERIES
1975-1985 23
Date: No.
FEBRUARY 1988 14
THIS BULLETIN APPLIES TO THE U.S. AND CANADA
REFERENCE: TP 30454/1 (ENGLISH); CI FUEL INJECTION - 4 CYLINDER TP 30592/1 (ENGLISH); CI FUEL INJECTION - 6 CYLINDER
Replacement fuel filter
Modified Mounting
Fuel filter P/N 1389450-6 has a modified nut attachment on the inlet side.
The size of the fuel filter nut has been increased from 19 mm to 27 mm. If a new-type filter is installed on an older vehicle, a slight modification is required.
REQUIRED PARTS: Description Part No. Quantity
Fuel Filter 1389450-6 1
Seal 947621-9 2
Seal 947282-0 2
Bracket 1336338-1 1
Bracket 1229284-3 1
Bolt 946934-7 1
Bolt 955127-6 1
Bolt 955138-3 1
Remove fuel filter from mounting bracket
- Place absorbent paper beneath fuel lines to collect spillage
- Slowly loosen nut on outlet side (fuel is under residual pressure)
- Disconnect fuel lines and remove filter.
Transfer nipple on outlet side of filter to new filter
- Fit new seal P/N 947282-0
Note direction of flow (bevelled side of nipple should face away from filter.)
Remove old mounting bracket
- Remove fuel line retaining clip.
- Remove mounting bracket.
Fit two new mounting brackets
- Place bracket P/N 1229284-3 below bulkhead insulation.
- Insert original screws in existing holes (lower left corner).
- Place bracket P/N 1336338-1 in position so that it aligns with old mounting bracket hole. Make sure that lug on mounting bracket fits into hole. Use new screw P/N 955138-3.
Fit new fuel filter
- connect fuel lines. Fit new seals on inlet side, P/N 947621-9.
Reconnect fuel return line
- Secure return line to bracket P/N 1229284-3 using original clip. Use new screw P/N 955127-6.
Test function
Start engine. Check for leakage. Correct as required.
Operation No. Labor Description Time Allowance
233426 New fuel filter mounting bracket, 0.4 hr.
install