3.6L

Generator Overview






1 Hex Bolt With Washer and Threaded Piece

• 2 Nm

• M4 x 20, M4 x 15

2 Protective Cap For Generator

Wiring bracket to the Generator

• 3 Nm

• M5

3 Phillips Head Screws

• 2 Nm

• M4 x 20

4 Protective Cap For Carbon Brushes

5 Voltage Regulator

• Removing and installing, refer to => [ Generator Voltage Regulator ] Service and Repair.

6 Generator

• Removing and installing, refer to => [ Generator ] Generator.

• Checking, refer to => [ Ribbed Belt, Checking ] Testing and Inspection.

• B+ wire mount, refer to => [ B+ Wire Connection to Generator ] Procedures.

• Removing and installing the ribbed belt pulley, refer to => [ Ribbed Belt Pulley on Generator ] Service and Repair.

7 Ribbed Belt

• Ribbed belt, checking, refer to=> [ Ribbed Belt, Checking ] Testing and Inspection.

• Removing and installing the ribbed belt pulley, refer to => [ Ribbed Belt Pulley on Generator ] Service and Repair.

8 Collar Bolts

• 20 Nm

• M8 x 90

No Illustration

• B+ wire nut to rear side of generator: 20 Nm

• Wire holder nut to the back of the generator: 3.2 Nm