Compression Check: Testing and Inspection

Compression Pressure, Checking

Special tools, testers and auxiliary items required

• Spark Plug Removal Tool (3122 B)

• Ignition Coil Puller (T40039)

• Torque Wrench (5-50 Nm) (V.A.G 1331)

• Compression Tester (V.A.G 1763)

• Adapter (V.A.G 1381/5A)

Test Conditions

• The engine oil temperature must be at least 30 °C (86 °F).

• The voltage supply is OK.

Procedure

- Remove the engine cover with air filter. Refer to => [ Engine Cover with Air Filter ] Engine Cover With Air Filter.

- Remover the ignition coils with the power output stage. Refer to => [ Ignition Coils with Power Output Stages ] Service and Repair.

- Remove the spark plugs using the spark plug removal tool (3122 B).

- Check the compression using the compression tester (V.A.G 1763) and the adapter (V.A.G 1381/5A).

• Using the tester, refer to the operating instructions.

- Have a second technician operate the starter.

- Operate the starter until the tester shows no further pressure increase.

Compression Pressure






- To complete the procedure, check the Engine Control Module (ECM) Diagnostic Trouble Code (DTC) memory and erase any DTCs that may have been stored when testing and making repairs.

• If the DTC memory was erased, the readiness code must be generated again. Refer to "Guided Fault Finding" in the vehicle diagnostic tester.