Daytime Running and Parking Lamp LED Module (L176)/(L177)

Daytime Running and Parking Lamp LED Module (L176)/(L177)

Special tools, testers and auxiliary items required

• Torque Screwdriver (VAS 6494) or equivalent

• The daytime running lamp module LED and the parking lamp are a complete single component and cannot be serviced. If the one of the LEDs in the module is faulty, then it is necessary to replace the complete component.

Removal

• Removing and installing is shown on the left side of the vehicle. Removing and installing the Right LED parking lamp/DRL module (L177) on the right side of the vehicle is identical.

- Remove front bumper cover.

- Disconnect the connector - 1 - for the daytime running lamp module LED and parking lamp from the front air guide - 2 -.






- Disconnect electrical connector - 1 -.

- Remove the air guide grille - 1 -.






- Remove screws - 1 -.






- Remove the daytime running lamp module and parking lamp LED - 1 - from the bumper.






- Guide the wiring harness - 3 - through the opening in the bumper - 2 -.

Installation

Install in reverse order of removal, noting the following:

- Install the daytime running lamp and parking lamp LED module into the opening in the bumper and tighten the screws - 1 -.






- Install the air guide grille - 1 -.

- Connect the connector - 1 - and attach the wiring harness to the front air guide grille - 2 -.






- Install front bumper cover.

• Make sure the daytime running lamp and parking lamp LED module is working correctly.

Tightening Specifications