Ignition Switch (D), Vehicles without KESSY

Ignition Switch (D), Vehicles without KESSY

Always follow the instructions regarding disconnecting and connecting the battery. Refer to => [ Battery (A), Disconnecting and Connecting ] Battery (A), Disconnecting and Connecting.

• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Read the safety precautions when performing work on the airbag. Refer to General Information.

Removing

- Disconnect the battery. Refer to => [ Disconnecting ] Disconnecting.

- Removing the steering wheel.

- Remove the steering column trim.

- Disconnect the connector - 2 - from the ignition switch - 1 -.






- Unlock the ignition switch with a small screwdriver - arrows -.

- Remove the ignition switch - 1 - from the steering lock housing.

Installing

- Install the ignition switch in the steering lock housing until it audibly latches.

- Insert the ignition key into the lock cylinder and turn the key to the "Run" position.

Lock cylinder key positions





1. Position "Off"

2. Position "Run"

3. Position "Start"


- Connect the battery. Refer to => [ Connecting ] Connecting.

Further installation is done in reverse order of removal.

Check the ignition switch, refer to => [ Ignition Switch (D), Checking ] Ignition Switch (D), Checking.