Operation CHARM: Car repair manuals for everyone.

Control Module and Hydraulic Unit, Installing







Control Module and Hydraulic Unit, Installing

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Torque Wrench (V.A.G 1410)

• Brake Pedal Actuator (V.A.G 1869/2)

• Do not remove sealing plugs at new hydraulic unit until the corresponding brake line is about to be installed.

• If the sealing plugs are removed too early, brake fluid can escape. If this occurs, unit may not be sufficiently filled or adequately bled.

• When installing, make sure that rubber installation pieces are not pressed out of console.

- Installation is performed in the reverse order of removal.

- Remove (V.A.G 1869/2).

- Bleed brake system. Refer to => [ Brake System, Bleeding ] Brake System, Bleeding.

- Connect the battery.

- Code ABS Control Module (J104) using -> Vehicle diagnostic tester in "Guided Fault Finding".

Tightening Specifications