Vehicle Electrical System Control Module (J519), from MY 10

Vehicle Electrical System Control Module (J519), from MY 10

• The relay carrier is clipped to the bottom of the vehicle electrical system control module and can be removed.

• If the vehicle electrical system control module is to be replaced, the work procedure to read out the codes stored in the module must always be performed. Refer to=> [ Vehicle Electrical System Control Module, Coding ] Vehicle Electrical System Control Module, Coding.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the relay panel from the vehicle electrical system control module. Refer to => [ Relay Carrier on Vehicle Electrical System Control Module, from MY 10 ] Relay Carrier on Vehicle Electrical System Control Module (J519), from MY 10.

- Press the catches - arrows - and swivel the vehicle electrical system control module downward.






- Pull the vehicle electrical system control module downward and opposite the drive direction and remove it from the bracket.

- Disconnect the connectors.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Insert the vehicle electrical system control module first with the back of the module into the bracket and push it up until it audibly latches.