Relay Carrier on Vehicle Electrical System Control Module (J519), from MY 10

Relay Carrier on Vehicle Electrical System Control Module (J519), from MY 10

• The relay carrier is clipped to the bottom of the vehicle electrical system control module and can be removed.


• Turn off the ignition and all electrical consumers.

• Remove the key.


When disconnecting and connecting the Battery, the procedure must be followed as described in the repair information. Refer to=> [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removal

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the trim in the driver footwell.

- Remove the left footwell lamp (W9). Refer to => [ Footwell Lamps/ ] Footwell Lamps (W9)/(W10).

• The wiring for the left footwell lamp and the diagnostic socket can remain connected.

- Remove the knee airbag in the driver footwell.

- Remove the metal traverse above the knee airbag.

- Release the tabs - arrows - and remove the relay panel - 2 - from the vehicle electrical system control module - 1 - opposite the drive direction toward the rear.






- Swivel the relay panel downward and unclip the relay. Be careful of the different wire lengths still connected.

Installation

Install in reverse order.