Ignition/Glow Plug System

Safety Precautions

To reduce the risk of personal injury and/or damage to the fuel injection and ignition system, always observe the following:

• Do not touch or remove the ignition wires with power output stages when the engine is running or turning at starter speed.

• The ignition must be switched off before connecting or disconnecting injection and ignition system wiring or tester cables.

• If engine is to be cranked at starting RPM without starting:

- Using the assembly tool (T10118), disconnect the electrical connectors from the ignition coils - 1 through 6 -.





If special testing equipment is required during a road test, note the following:

• Test and measuring instruments must be secured in the rear seat and operated by a second person from this location.

If test and measuring instruments are operated from the front passenger seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.