Operation CHARM: Car repair manuals for everyone.

Positive Crankcase Ventilation Heating Element Checking







Positive Crankcase Ventilation Heating Element Checking

• Use only gold-plated terminals when servicing terminals in the electrical harness connector of Positive Crankcase Ventilation (PCV) Heating Element (N79).

Special tools, testers and auxiliary items required

• Multimeter.

• Wiring diagram.

Test requirements

• Fuse (SA1) OK.

• Fuse (SA5) OK.

• Fuse (SC1) OK.

• Battery voltage at least 12.5 volts.

• All electrical consumers such as, lights and rear window defroster, switched off.

• Vehicles with automatic transmission, shift selector lever into position "P" or "N".

• A/C switched off.

• Ground connections between engine/transmission/chassis OK.

• Ignition switched off.

• Engine cold.

Test procedure

- Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] Preliminary Check.

Start diagnosis

- Disconnect the Positive Crankcase Ventilation (PCV) Heating Element (N79) electrical harness connector.

- Using a multimeter, check the Positive Crankcase Ventilation (PCV) Heating Element (N79) terminals 1 to 2 for resistance.





Specified value: 25 to 35 ohms (at approx. 20° C)

If the specified value was not obtained:

- Replace the Positive Crankcase Ventilation (PCV) Heating Element (N79).

If the specified value was obtained:

Checking voltage

Switch the ignition On.

- Using a multimeter, check the Positive Crankcase Ventilation (PCV) Heating Element (N79) electrical connector terminal 1 to Ground for voltage.





Specified value: Battery voltage.

Switch the ignition Off.

If the specified value was Not obtained:

- Check the wiring from the Positive Crankcase Ventilation (PCV) Heating Element (N79) electrical connector terminal 1 to the Battery positive for an open circuit, high resistance, or a short circuit to Ground.

- Check the electrical harness connector for damage, corrosion, loose or broken terminals.

- If necessary, repair the wiring connection.

If the specified value was obtained:

Checking Ground

- Using a multimeter, check the Positive Crankcase Ventilation (PCV) Heating Element (N79) electrical connector terminal 2 to Ground for resistance.





Specified value: 1.5 ohms Max.

If the specification was Not obtained:

- Check the wiring for an open circuit, high resistance, a short circuit to each other, Battery or Ground.

- Check the electrical harness connector for damage, corrosion, loose or broken terminals.

- If necessary, repair the faulty wiring connection.

If the specification was obtained:

- Replace the Positive Crankcase Ventilation (PCV) Heating Element (N79).

Final procedures

After repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] Diagnostic Modes 01 - 09.

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] Diagnostic Modes 01 - 09.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] Monitors, Trips, Drive Cycles and Readiness Codes.