Operation CHARM: Car repair manuals for everyone.

Fuel Pressure Regulator and Residual Pressure, Checking






Fuel Pressure Regulator and Residual Pressure, Checking

• Follow all safety precautions. Refer to => [ Safety Precautions ] Multiport Fuel Injection.

• Pay attention to the rules of cleanliness. Refer to => [ Clean Working Conditions ] Multiport Fuel Injection.

Special tools, testers and auxiliary items required

• Pressure Tester (VAS 6550)

• The fuel pump function must be checked. Refer to => [ Function and Voltage Supply, Checking ] Testing and Inspection.

• The fuel pressure regulator regulates the fuel pressure to approximately 4 bar.

• The fuel pressure regulator is located on the fuel filter. From 10.05, the fuel pressure regulator is integrated in the fuel filter and cannot be replaced separately.

• Follow all safety precautions. Refer to => [ Safety Precautions ] Multiport Fuel Injection.

• Pay attention to the rules of cleanliness. Refer to => [ Clean Working Conditions ] Multiport Fuel Injection.


The fuel system is under pressure!

• Always wear protective eyewear and protective clothing to prevent injuries and fuel from coming in contact with your skin.

• Before loosening line connections, place a cloth around the connection point. Then release pressure by carefully pulling off the line.

- Disconnect the fuel supply line - 3 -. Press the circlip upward into the housing to release the line - 3 -.






- Connect the pressure tester (VAS 6550) to the fuel supply line using the adapter hoses (VAS 6550/1) and (VAS 6550/2).






- Make sure the drain is closed and the shut off levers are open.

- Start the engine and run at idle speed.

• If the engine does not start, activate the fuel pump with the output diagnostic test mode.

- Check the fuel pressure on the pressure tester.

• Specified value: 3.8 to 4.2 bar

If the fuel pressure is OK, check the residual pressure.

If the Specification is Exceeded:

- Check the fuel return line between the fuel filter and the flange for possible restrictions (kinks) or blockages.

If no malfunction can be found:

- The fuel pressure regulator is faulty. Replace it.

If the Specification is Not Obtained:

- Check the fuel lines for possible restrictions (kinks) or blockages.

If no malfunction can be found:

- Replace the fuel pressure regulator.

• From 10.05, the fuel pressure regulator is integrated into the fuel filter and cannot be replaced separately.

- Repeat the test.

If the Specification is Again Not Obtained:

- Replace the fuel delivery unit, the fuel pump is faulty. Refer to => [ Fuel Delivery Unit ] Service and Repair.

If the specification is not reached, check the residual pressure as follows:

- Watch the pressure decrease on the pressure tester.






• After 10 minutes the pressure must not drop below a 3.0 bar decrease.

If the pressure drops further:

- Start the engine and run at idle speed.

- Turn the ignition off and close the pressure tester shut off lever - B - immediately.






If the Pressure No Longer Drops Now:

Check for the leak on the engine side. Repeat the residual pressure check. Close the shut off lever - A - this time to determine if there actually is a leak on the engine side.

- Check the fuel rail and fuel injectors for leaks.

If the Pressure Drops Again:

The leak is on the fuel tank side.

- Check the fuel lines for leaks.

If no malfunctions are found in the fuel lines:

- Test the fuel pump check valve. Refer to => [ Fuel Pump Check Valve, Checking ] Testing and Inspection.

If no malfunction is found here either:

- Replace the fuel pressure regulator => [ (Item 5) Fuel Pressure Regulator ] Fuel Filter Overview.

• From 10.05, the fuel pressure regulator is integrated in the fuel filter and cannot be replaced separately.

- Bleed the fuel supply system. Refer to => [ Fuel System, Bleeding ] Service and Repair.