Powertrain Management: Technical Service Bulletins

• Recalls
  • Generals
    • Campaign - ECM Replacement
      • Overview
      • Work Procedure
        • A. Check ECM - 1996 Golf, Jetta, GTI 4-CYL. Only
        • B. Replace Engine Control Module (ECM) All Models
  • Safety
    • Recall 02V256000: Ignition Switch Replacement
• Customer Interest
  • Computers/Controls - No Communication With Scan Tools
  • A/T - Erratic, Harsh or Delayed Upshifts, No DTCs Set
    • Overview
    • Service
  • Engine - Poor Idle Quality
  • A/T - Erratic Shifting, No DTCs Stored in TCM
• By Symptom
  • Customer Interest
    • Computers/Controls - No Communication With Scan Tools
    • A/T - Erratic, Harsh or Delayed Upshifts, No DTCs Set
      • Overview
      • Service
    • Engine - Poor Idle Quality
    • A/T - Erratic Shifting, No DTCs Stored in TCM
  • Driveability
    • Engine - Poor Idle Quality
  • Erratic Shifting
    • A/T - Erratic, Harsh or Delayed Upshifts, No DTCs Set
      • Overview
      • Service
  • Hard Shifting
    • A/T - Erratic, Harsh or Delayed Upshifts, No DTCs Set
      • Overview
      • Service
  • Recalls
    • Campaign - ECM Replacement
      • Overview
      • Work Procedure
        • A. Check ECM - 1996 Golf, Jetta, GTI 4-CYL. Only
        • B. Replace Engine Control Module (ECM) All Models
    • Recall 02V256000: Ignition Switch Replacement
• All Technical Service Bulletins
  • Computers/Controls - No Communication With Scan Tools
  • Mass Air Flow Sensor - Coated With Oil
    • Overview
    • Service Procedure
  • Speed Sensors - Location and Trouble Codes
  • Engine Controls - Additional OBDII DTC's
  • A/T - Erratic, Harsh or Delayed Upshifts, No DTCs Set
    • Overview
    • Service
  • Campaign - ECM Replacement
    • Overview
    • Work Procedure
      • A. Check ECM - 1996 Golf, Jetta, GTI 4-CYL. Only
      • B. Replace Engine Control Module (ECM) All Models
  • Post Oxygen Sensor - New Part Identifier
  • Recall 02V256000: Ignition Switch Replacement
  • A/T - New DTC's Recognized by Control Module
  • Engine Controls - New Readiness Code Creating Procedure
    • Overview
    • Work Step 1 and 2
    • Work Step 3 and 4
    • Work Step 5
    • Work Step 6
    • Work Step 7
    • Work Step 8
    • Work Step 9
    • Work Step 10
    • Work Step 11
    • Work Step 12
    • Work Step 13
    • Work Step 14 and 15
    • Work Step 16
    • Work Step 17
    • Work Step 18
    • Work Step 19
    • Work Step 20
    • Work Step 21
    • Work Step 22
  • Engine - Poor Idle Quality
  • A/T - Erratic Shifting, No DTCs Stored in TCM
  • A/T - Valve Body Conductor Strip Removal/Installation
  • Engine Controls - Silicone Sealer/Lubricant Precautions