Glow Plug System: Description and Operation
During cold starts, diesel compression heat is dissipated rapidly through the cold engine so that a preheating provision is necessary to ensure compression ignition. The glow plugs are threaded into the cylinder head so they project into each combustion chamber. A heating element in each plug gets red hot whenever current is applied to the plug terminals.Current is supplied to the glow plugs directly from the battery by a relay that is controlled by the Turbocharged Direct Injection (TDI) diesel Engine Control Module (ECM). A temperature sensor connected to the ECM controls preheating time. The colder the temperature, the longer the preheating time. The glow plug light is on when the plugs are being heated and goes off when the engine is ready to start.
Defective glow plugs cause hard starting and rough running during warm-up. Carbon deposits can build up and insulate the heating element. If the system seems satisfactory, but the engine is hard to start, the glow plugs should be removed for cleaning.
Most problems in the preheat system can be found with a test light. Glow plugs can also be checked with an ohmmeter. The resistance value is about .25 ohms.