A/T - Shiftlock III System Checking, Service/Disassembly: Overview
GROUP: 37NUMBER: 93-O2
DATE: April 15, 1993
SUBJECT:
Shiftlock III system, checking/servicing/disassembling
MODEL(s):
Corrado from m.y. 1993
Shiftlock III, system operation
CAUTION
Before working on a running engine, always:
^ place selector lever in P
^ engage parking brake
CHECKING WITH SELECTOR LEVER IN P
Note
During the checking procedure, DO NOT operate the brake pedal until instructed to do so.
- place selector lever in P
- turn ignition ON
- try shifting selector lever out of P
^ it must NOT be possible to shift out of P
If selector lever can be shifted out of P
^ shiftlock system is malfunctioning:
solenoid is NOT triggering a "blocking" action at selector lever
If selector lever cannot be shifted out of P
^ shiftlock mechanism is functioning: solenoid HAS triggered a "blocking" action at selector lever
^ apply brake pedal and hold
^ shift selector lever out of P
If selector lever cannot be shifted out of P
^ shiftlock system is malfunctioning: solenoid is NOT being deactivated to release selector lever
If selector lever can be shifted out of P
^ system is functioning: solenoid IS deactivated to release selector lever
CHECKING WITH SELECTOR LEVER IN N
Note
Repeat checking procedure, this time with selector lever in N (ignition ON). As before, DO NOT operate the brake pedal until instructed to do so. The results must be identical to those specified for checking with the selector lever in P.
CHECKING WITH VEHICLE IN MOTION
- operate vehicle at speeds OVER 5 km/h (3 mph)
- shift selector lever into N
^ shift lock solenoid must NOT block block selector lever (e.g. it must be possible to shift back into D)
- operate vehicle at speeds UNDER 5 km/h (3 mph)
- shift selector lever into N
^ shiftlock solenoid MUST block the selector lever after one second (e.g. it must NOT be possible to shift back into D)
Note
Once the brake pedal is applied, however, the selector lever can again be shifted out of the N position.
ADDITIONAL FUNCTION CHECK
^ check that vehicle will NOT start with selector lever in positions R, D, 3, 2, or 1
IGNITION LOCK MECHANISM, CHECKING
- place selector lever in P position
- turn ignition key to OFF position
^ remove key
^ it must NOT be possible to remove key with ignition switch in any other position but OFF.
- attempt to shift selector lever (with key removed)
^ it must NOT be possible to shift selector lever out of P