Lock Cable Adjusting

LOCK CABLE, ADJUSTING

CAUTION
Always adjust lock cable while installed.

- place selector lever in position 1
- turn ignition key to the right, i.e. "start position," then release




- adjust play between lever 1 and pin 2 by sliding lock cable sleeve

^ dimension a = 0.7 mm

- tighten bolt for lock cable anchor to 6 Nm (53 in. lb or 61 cm kg), while maintaining dimension a
- place selector lever in position P
- turn ignition key to last position, and remove

Note
It must NOT be possible:

^ to remove key in any selector lever position except P

^ to shift out of selector lever position P with key removed