Operation CHARM: Car repair manuals for everyone.

Engine: Service and Repair


1. Disconnect battery ground cable.
2. Place temperature control lever in Warm position, then open radiator cap.
3. Remove 5 power steering pump attaching bolts and the pump drive belt, then position pump aside, leaving fluid lines attached.
4. Disconnect lower hose from water pump and drain cooling system.
5. Disconnect coolant hose from cylinder head.
6. Disconnect electrical connectors from thermo-time switch, alternator, oil pressure switch and control pressure regulator.
7. Disconnect vacuum hoses from distributor.
8. Remove control pressure regulator attaching bolts and position aside, leaving fuel lines attached.
9. Disconnect electrical connectors from radiator fan switch and fan.
10. Remove radiator, air duct and fan as an assembly.
11. On manual transaxle models, disconnect clutch cable from transaxle.
12. On all models, remove attaching nut from left engine mount.
13. Disconnect hall sender electrical connector and coil wire from distributor.
14. Disconnect electrical connectors from coolant temperature sender and oxygen sensor thermo-switch.
15. Disconnect remaining coolant hoses.
16. Disconnect electrical connectors from cold start valve, frequency valve and oxygen sensor.
17. Remove charcoal filter valve from air duct and remove the duct.
18. Remove pre-heater hose, then the cold start valve with fuel line attached.
19. Disconnect vacuum hoses from intake manifold, then remove accelerator cable.
20. Disconnect crankcase breather and brake booster hoses.
21. Disconnect electrical connector from auxiliary air regulator.
22. Remove injectors, leaving fuel lines attached.
23. Loosen fuel distributor and air filter housing and position aside.
24. On models without air conditioning, remove front engine mount.
25. On all models, disconnect front exhaust pipe from exhaust manifold.
26. Disconnect electrical connectors from starter motor.
27. Remove right engine mount attaching nuts.
28. Remove starter motor attaching bolts, then lower transaxle-to-engine attaching bolts.
29. Remove flywheel cover plate.
30. On automatic transaxle models, remove starter motor, then torque converter attaching bolts.
31. On all models, support transaxle with tool VW-785/1B or equivalent.
32. On models equipped with air conditioning, proceed as follows:
a. Remove front engine mount attaching bolts and the mount.
b. Loosen crankshaft pulley outer nuts and remove drive belt.
c. Remove both upper bolts from compressor mounting bracket.
d. Remove 3 lower bolts from compressor mounting bracket, then position compressor and bracket aside, leaving refrigerant lines attached.
33. On all models, attach engine lifting tool US-1105 or equivalent to engine and raise engine slightly.
34. Remove right engine mount, then tension transaxle supporting tool and remove upper transaxle-to-engine attaching bolts.
35. Separate engine from transaxle, then carefully lift engine from vehicle.
36. Reverse procedure to install.