Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. REMOVE REAR NO. 3 FLOOR BOARD Removal

3. REMOVE DECK FLOOR BOX RH Removal

4. REMOVE REAR NO. 3 FLOOR BOARD UPPER PLATE Removal

5. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

7. REMOVE ASSIST GRIP COVER Disassembly

8. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly

9. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Removal

10. REMOVE DOOR ARMREST COVER Disassembly

11. REMOVE COURTESY LIGHT ASSEMBLY Removal

12. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

13. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly

14. REMOVE FRONT DOOR TRIM BRACKET Disassembly

15. REMOVE FRONT DOOR SERVICE HOLE COVER Disassembly

16. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly

17. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY Disassembly

18. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and the front power window regulator motor assembly.