Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: REMOVAL
NOTICE:
* Do not remove the steering angle sensor from the spiral cable.
* While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.
1. REMOVE STEERING WHEEL ASSEMBLY
Removal
2. REMOVE LOWER STEERING COLUMN COVER Removal
3. REMOVE UPPER STEERING COLUMN COVER Removal
4. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
(a) Remove the spiral cable with sensor sub-assembly Removal.
NOTICE:
* Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
* Do not rotate the the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
* Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
* Do not remove the steering angle sensor from the spiral cable.