Operation CHARM: Car repair manuals for everyone.

Installation





DOOR LOCK: BACK DOOR LOCK: INSTALLATION

1. INSTALL BACK DOOR LOCK ASSEMBLY

HINT
Make sure to remove the string before installing a new back door lock assembly.

(a) Apply MP grease to the sliding parts of the back door lock assembly.

(b) Install the back door lock assembly with the 3 bolts.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

(c) Engage the 4 clamps and connect the connector.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Installation

3. INSTALL TONNEAU COVER HOLDER CAP Installation

4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation

5. INSTALL REAR DECK TRIM COVER Installation

6. INSTALL DECK TRIM SERVICE HOLE COVER Installation

7. INSTALL REAR NO. 1 FLOOR BOARD Installation

8. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY Installation

9. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY Installation

10. INSTALL DECK FLOOR BOX LH

HINT
Use the same procedure for the RH side and LH side.

11. INSTALL REAR NO. 4 FLOOR BOARD SUB-ASSEMBLY Installation

12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Installation

13. INSTALL DECK FLOOR BOX RH Installation

14. INSTALL REAR NO. 3 FLOOR BOARD Installation

15. INSTALL REAR NO. 2 FLOOR BOARD Installation

16. INSTALL REAR SIDE SEATBACK ASSEMBLY LH Installation

17. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

18. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation

19. INSTALL REAR DOOR SCUFF PLATE LH Installation