Blower Motor Resistor: Service and Repair
Blower Resistor:
Blower Resistor:
BLOWER RESISTOR
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Hatchback)
3. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Sedan)
4. REMOVE BLOWER RESISTOR
a. Pull back the floor carpet.
b. Disconnect the connector.
c. Remove the 2 screws and the blower resistor.
If the resistance value is not as specified, replace the blower resistor.
INSTALLATION
1. INSTALL BLOWER RESISTOR
a. Install the blower resistor with the 2 screws.
b. Connect the connector.
c. Install the floor carpet.
2. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Hatchback)
3. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH (for Sedan)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)