Operation CHARM: Car repair manuals for everyone.

Diagnosis System

DIAGNOSIS SYSTEM

1. BUS CHECK

HINT: The ECUs and sensors that are properly connected to the CAN communication system can be displayed using the intelligent tester via the CAN VIM.




a. Select "BUS CHECK" from the "OBD / MOBD MENU" screen.




b. Press "ENTER" on the intelligent tester via the CAN VIM.




c. The screen displays the ECUs and sensors that are properly connected to the CAN communication system.

HINT: There is a communication stop in the system of any properly connected ECUs or sensors that are not displayed.

2. CHECK FOR INSTALLED SYSTEMS (ECU & SENSOR) THAT USE CAN COMMUNICATION




a. The systems (ECU, sensor) that use CAN communication vary depending on the vehicle's optional settings. Check which systems (ECU, sensor) are installed on the vehicle.

HINT: If enhanced VSC is not installed, neither the yaw rate sensor nor the steering angle sensor is used.

3. DTC TABLE BY ECU

HINT: If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting according to "HOW TO PROCEED WITH TROUBLESHOOTING".




a. HYBRID VEHICLE CONTROL ECU

HINT: DTC communication uses the CAN communication system.




b. BATTERY ECU

HINT: DTC communication uses the CAN communication system.




c. ECM

HINT: DTC communication uses the CAN communication system.




d. SKID CONTROL ECU

HINT: DTC communication uses the SIL line.

with Enhanced VSC

e. GATEWAY ECU

HINT: The gateway ECU is connected to the CAN communication system but CAN communication system DTCs are not output.




f. POWER STEERING ECU

HINT: DTC communication uses the SIL line.

4. DTC COMBINATION TABLE




a. Perform troubleshooting according to the combination of DTCs output.

NOTE:
- If U0146 or P3108-594 is output, check the "MULTIPLEX COMMUNICATION SYSTEM" before proceeding to "GATEWAY ECU COMMUNICATION STOP MODE".
- If U0100-211 or U0111-208 is output separately by the hybrid control ECU, refer to "HYBRID CONTROL SYSTEM".

HINT:
- HYBRID VEHICLE CONTROL ECU COMMUNICATION STOP MODE.
- ECM COMMUNICATION STOP MODE.
- BATTERY ECU COMMUNICATION STOP MODE.
- SKID CONTROL ECU COMMUNICATION STOP MODE.
- STEERING ANGLE SENSOR COMMUNICATION STOP MODE.
- YAW RATE SENSOR COMMUNICATION STOP MODE.
- POWER STEERING ECU COMMUNICATION STOP MODE.
- GATEWAY ECU COMMUNICATION STOP MODE.