Removal and Installation

REMOVAL

1. REMOVE FAN AND GENERATOR V BELT




2. REMOVE GENERATOR ASSEMBLY
a. Disconnect the engine wire.
b. Remove the 2 bolts and generator as shown in the illustration.

INSTALLATION




1. INSTALL GENERATOR ASSEMBLY
a. Confirm that the wire harness of the crankshaft position sensor is placed as shown in the illustration.
b. Install the generator.

Torque: 21 N.m (214 kgf.cm, 15 ft.lbf) for M8
52 N.m (530 kgf.cm, 38 ft.lbf)
9.0 N.m (92 kgf.cm, 80 in.lbf) for wiring harness clamp
9.8 N.m (100 kgf.cm, 87 in.lbf) for generator wire

NOTE: Be careful not to put the wire harness in when installing the alternator.

2. INSTALL FAN AND GENERATOR V BELT