Operation CHARM: Car repair manuals for everyone.

Ignition Coil: Service and Repair

REMOVAL

1. REMOVE REAR NO. 2 FLOOR BOARD
2. REMOVE REAR DECK FLOOR BOX
3. REMOVE REAR NO. 3 FLOOR BOARD
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.




5. DISCONNECT ENGINE ROOM NO. 2 RELAY BLOCK
a. Remove the 2 bolts and disconnect the relay block.

6. REMOVE IGNITION COIL ASSEMBLY
a. Disconnect the 4 ignition coil connectors.




b. Remove the 4 bolts and pull out the 4 ignition coils.

INSTALLATION




1. INSTALL IGNITION COIL ASSEMBLY
a. Install the 4 ignition coils with the 4 bolts.

Torque: 9.0 N.m (90 kgf.cm, 80 in.lbf)

b. Connect the 4 ignition coil connectors.




2. INSTALL ENGINE ROOM NO. 2 RELAY BLOCK
a. Install the relay block with the 2 bolts.

Torque: 8.4 N.m (86 kgf.cm, 74 in.lbf)

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. INSTALL REAR NO. 3 FLOOR BOARD
5. INSTALL REAR DECK FLOOR BOX
6. INSTALL REAR NO. 2 FLOOR BOARD
7. PERFORM INITIALIZATION
a. Perform initialization

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.