Programming and Relearning

PRECAUTION

NOTE: When disconnecting the negative (-) battery terminal, initialize the following system after the terminal is reconnected.
- Power Window Control System

NOTE:
- When the warning lamp is illuminated or the battery has been disconnected and reconnected, pressing the power switch may not start the system on the first try. If so, press the power switch again.
- With the power switch's power mode changed to ON (IG), disconnect the battery. If the key is not in the key slot during reconnection, DTC B2799 may be output.

HANDLING PRECAUTIONS FOR AIR BAG SENSOR

HINT: The air bag sensors include the air bag ECU assembly, air bag sensor front LH, air bag sensor front RH, side air bag sensor assembly LH, side air bag sensor assembly RH, air bag sensor rear LH, air bag sensor rear RH and seat position air bag sensor.

a. Make sure that the power switch is off and wait at least 90 seconds after disconnecting the negative (-) terminal cable of the battery when performing the following.
1. Replacement of the air bag sensors
2. Adjustment of the front or rear door a vehicle equipped with a front seat air bag and curtain shield air bag

b. When connecting or disconnecting the connectors, ensure that the air bag sensors have already been installed in the vehicle.
c. Do not use air bag sensors that have been dropped during the operation or transportation.
d. When installing the air bag sensors, ensure that they are affixed using the specified torque.
e. Do not disassemble the air bag sensors.