Operation CHARM: Car repair manuals for everyone.

Removal and Installation

Compressor And Magnetic Clutch:






REMOVAL

1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES
2. STOP ENGINE
3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY
4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
5. REMOVE ENGINE UNDER COVER
6. REMOVE DRIVE BELT




7. DISCONNECT DISCHARGE AND SUCTION HOSES FROM COMPRESSOR
Remove the 2 bolts and disconnect the both hoses.

NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.




8. REMOVE COMPRESSOR
a. Disconnect the connector.
b. Remove the 3 bolts and compressor.

INSTALLATION

1. INSTALL COMPRESSOR
a. Install the compressor with 3 bolts.

Torque: 25 N.m (250 kg.cm, 18 ft. lb)

b. Connect the connector.

2. CONNECT DISCHARGE AND SUCTION HOSES
a. Lubricate 2 new O-rings with compressor oil and install them to the hoses.
b. Connect the both hoses with 2 bolts.

Torque: 10 N.m (100 kg.cm, 7 ft.lb)

NOTE: Hose should be connected immediately after the caps have been removed.

3. INSTALL AND CHECK DRIVE BELT
4. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY
5. EVACUATE AIR FROM REFRIGERATION SYSTEM CHARGE SYSTEM WITH REFRIGERANT

Specified amount: 650 ± 50 g (22.93 ± 22.93 oz.)

6. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.

7. INSPECT A/C OPERATION