Operation CHARM: Car repair manuals for everyone.

Component Tests and General Diagnostics

1. DISCONNECT COMBINATION MATER
2. DISCONNECT ECM
3. INSPECT A/C CONDITIONING CONTROL SYSTEM CIRCUIT
a. Disconnect the connector from the combination meter and inspect the connector on the wire harness side as shown in the diagram below.

Test condition:
Turn ignition switch to ON







If the circuit is not as specified, inspect the circuits connected to other parts.

b. Reconnect the connector to combination meter and inspect the wire harness side from the back side, as shown in the diagram below.

Test condition:
- Run engine at idle speed
- Set on manifold gauge set







If the circuit is not as specified, inspect the circuits connected to other parts.

c. Inspect the wire harness side connector of the ECM from the back side, as shown in the diagram below.







If the circuit is not as specified, inspect the circuits connected to other pants.

4. RECONNECT ECM
5. RECONNECT COMBINATION METER