Canada - Cruise Control - A Shock Feeling
Bulletin
0869
Issue Date
2000-10-26
Reference
BE-00-013
Model
Celica
Year Range
2000
Market
Canada
Component
BE
Subject:
CRUISE CONTROL SHOCK
A new cruise control computer has been developed for the 2000 model year Celica. The new computer significantly reduces a shock feeling which may occur when using the cruise control during a long drive. To address this condition, replace the cruise control ECU and perform the cable adjustment as shown in this bulletin.
APPLICABLE VEHICLES:
2000 model year Celica equipped with cruise control produced prior to the VINs listed below.
PRODUCTION CHANGE INFORMATION:
PART NUMBER INFORMATION:
REPAIR PROCEDURE:
1. Replace cruise control ECU. Perform the cable adjustment procedure as necessary.
2. Confirm cable free play:
A. Eliminate slack of inner cable by pushing it towards the actuator until it stops. While the cable is held tight, mark the position of the cable by using tape.
B. Pull the inner cable toward the throttle cam and measure the free play between the tape mark and the outer cable tip.
3. Adjust the cable free play:
A. Loosen the throttle cam side lock nut and adjust the free play to 1 or 2mm. (Please refer to illustration above.)
B. Tighten the actuator side lock nut.
Torque: 12N-m/8 ft-lbs
C. Confirm free play of 1 to 2mm.
REPAIR TIME:
NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.