Except California
CONFIRMATION ENGINE RACING PATTERN
1. Connect the TOYOTA hand-held tester to the DLC3, or connect the probe of the oscilloscope between terminals OXR1, OXL1, OXS and E1 of the ECM connector.
2. Start the engine and warm it up with all the accessories switched OFF until the water temperature is stable.
3. Race the engine at 2,500 - 3,000 rpm for about 3 min.
4. After confirming that the waveform of the heated oxygen sensor (bank 1, 2 sensor 1 (OXR1, OXL1)), oscillate around 0.5 V during feedback to the ECM, check the waveform of the heated oxygen sensor (bank 1 sensor 2 (OXS)).