Operation CHARM: Car repair manuals for everyone.

Transmission Position Sensor/Switch: Service and Repair


PARK/NEUTRAL POSITION (PNP) SWITCH

ON-VEHICLE REPAIR

1. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR





2. REMOVE PARK/NEUTRAL POSITION SWITCH
a) Disconnect the control cable from the control shaft lever.
b) Remove the nut and the control shaft lever.
c) Using a screwdriver, pry off the nut stopper.
d) Remove the nut and the nut stopper.
e) Remove the 2 bolts and the park/neutral position switch.

3. INSTALL PARK/NEUTRAL POSITION SWITCH
a) Install the park/neutral position switch with 2 bolts.

Torque: 5.4 Nm (55 kgf-cm; 48 in. lbs.)

b) Install the nut stopper and nut.

Torque: 6.9 Nm (70 kgf-cm,61 in. lbs.)

c) Stake the nut with the lock plate.
d) Install the control shaft lever and nut.

Torque: 12 Nm (120 kgf-cm; 9 ft. lbs.)

e) Connect the control cable to the control shaft lever.

Torque: 12 Nm (120 kgf-cm; 9 ft. lbs.)

4. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
5. CHECK PARK/NEUTRAL POSITION SWITCH OPERATION
Check that the engine can be started with the shift lever only in the N or P position,but not in other positions. If not as stated above, carry out the adjustment procedure.

6. TEST DRIVE VEHICLE