Operation CHARM: Car repair manuals for everyone.

Ignition Timing: Testing and Inspection

INSPECTION

1. Warm up engine.
Allow the engine to warm up to normal operating temperature.
2. Connect Toyota hand-held tester or OBD II scan tool.



a. Connect the Toyota hand-held tester or OBD II scan tool to the DLC3.
b. Please refer to the Toyota hand-held tester or OBD II scan tool operator's for further details.

3. Connect timing light to engine.
4. Inspect ignition timing.



a. Using Special Service Tool (SST) 09843-18020 or equivalent, connect terminals TE1 and E1 of the DLC1.

HINT: After engine rpm is kept at 1,000-1,300 rpm for 5 seconds, check that it returns to idle speed.




b. Using a timing light, check the ignition timing.
Ignition timing: 8 - 12° BTDC @ idle
(Transmission in neutral position)
c. Remove the SST 09843-18020 from the DLC1.

5. Further check ignition timing.
Ignition timing: 6 - 15° BTDC @ idle
(with transmission in neutral position)
HINT: The timing mark moves in a range between 6° and 15°.

6. Disconnect timing light from engine.
7. Disconnect Toyota hand-held tester or OBD II scan tool.