Operation CHARM: Car repair manuals for everyone.

Alignment: Service and Repair

INSPECTION






1. Measure vehicle height.


*1: Front measuring point
Measure from the ground to the center of the front side lows suspension arm mounting bolt.
*2: Rear measuring point
Measure from the ground to the center of the front side strut rot mounting bolt.


Tire Size: 175/65R 14
Height (Front): 185 mm (7.28 inch).
Height (Rear): 245 mm (9.65 inch).
Tire Size: 185/65R 14
Height (Front): 190 mm (7.48 inch).
Height (Rear): 250 mm (9.84 inch).

NOTICE:
- Before inspecting the wheel alignment, adjust the vehicle height to the specification.
- If the vehicle height is not within the specification, try to adjust it by pushing down on or lifting the body.






2. Install camber-caster-kingpin gauge or tire onto wheel alignment tester.
Follow the specific instructions of the equipment manufacturer.





3. Inspect camber, caster and steering axis inclination.
If the caster and steering axis inclination are not within the specification, after the camber has correctly adjusted, recheck the suspension parts for damaged and/or worn-out parts.

Measuring Point Reference:





4. Inspect toe-in.
Toe In: A + B: 0°6' ± 12' (0.1° ± 0.2°)
- Total C - D: 1 ± 2 mm (0.04 ± 0.08 inch)
If the toe-in is not within the specification, adjust it at the rack end.





5. Adjust camber.

NOTICE: After the camber has been adjusted, inspect the toe-in.

a. Remove the front wheels.
b. Remove the 2 nuts on the lower side of the shock absorber.
c. Coat the nut's threads with engine oil.
d. Temporarily install the 2 nuts.





e. Adjust the camber by pushing or pulling the lower side of the shock absorber in the direction in which the camber adjustment is required.
f. Tighten the nuts.
Torque: 274 Nm (203 ft. lbs.)
Install the front wheels.
Torque: 103 Nm (76 ft. lbs.)
h. Check the camber.

HINT:
- Try to adjust the camber to the center value.
- Adjusting value for the set bolts is 6'- 30' (0.1° - 0.5°).






If the camber is not within the specification, using the table below, estimate for how much additional camber adjustment will be required, and select the camber adjusting bolt.





i. Follow the above mentioned steps again. Between step b. and c, exchange 1 or 2 selected bolts.

HINT: When exchanging the 2 bolts, exchange 1 bolt for each time.






6. Adjust toe-in.
a. Remove the boot clamps.
b. Loosen the tie rod end lock nuts.
c. Turn the left and right rack ends an equal amount to adjust the toe-in.






HINT:
- Try to adjust the toe-in to the center value.
- Make sure that the length of the left and right rack ends is the same.

Rack end length difference: 1.0 mm (0.039 inch) or less
d. Torque the tie rod end lock nuts.
Torque: 56 Nm (41 ft. lbs.)
e. Place the boot on the seat and install the clamp.

HINT: Make sure that the boots are not twisted.






7. Inspect wheel angle.
Turn the steering wheel fully, and measure the turning angle.






If the wheel angles differ from the standard specifications, adjust the toe-in.