Operation CHARM: Car repair manuals for everyone.

Compressor HVAC: Service and Repair




COMPONENTS

REMOVAL
1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES

2. STOP ENGINE

3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY

4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

5. REMOVE ENGINE UNDER COVER

6. REMOVE DRIVE BELT




7. DISCONNECT DISCHARGE AND SUCTION HOSES FROM COMPRESSOR

Remove the 2 bolts and disconnect the both hoses.

NOTE: Cap the open fillings immediately to keep moisture or dirt out of the system.




8. REMOVE COMPRESSOR
a. Disconnect the connector.
b. Remove the 3 bolts and compressor.

INSTALLATION
1. INSTALL COMPRESSOR

a. Install the compressor with 3 bolts.
Torque: 25 N.m (250 kgf.cm, 18 ft.lbf)
b. Connect the connector.

2. CONNECT DISCHARGE AND SUCTION HOSES
Connect the both hoses with 2 bolts.
Torque: 10 N.m (100 kgf.cm, 7 ft.lbf)

NOTE: Hose should be connected immediately after the caps have been removed.

HINT: Lubricate 2 new O-rings with compressor oil and install the hoses

3. INSTALL AND CHECK DRIVE BELT

4. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY

5. EVACUATE AIR FROM REFRIGERATION SYSTEM CHARGE SYSTEM WITH REFRIGERANT

Specified amount: 650 ± 50 g (22.93 ± 22.93 oz.)

6. INSPECT FOR LEAKAGE OF REFRIGERANT

Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.

7. INSPECT A/C OPERATION