Operation CHARM: Car repair manuals for everyone.

Rear

INSPECTION
1. Measure vehicle height.
2. Install camber-caster-kingpin gauge or position vehicle on wheel alignment tester.
Follow the specific instructions of the equipment manufacture.
3. Inspect Camber.
Camber: -1°10' ± 45' (-1.17° ± 0.75°).
Left- Right Error: 45' (0.75°) or less.
Camber is not adjustable, if measurement is not within specification, inspect and replace the suspension parts as necessary.

Measuring Point Reference:





4. Inspect toe-in.
The Toe-In (total):
- A + B: 0°21' ± 12' (0.35° ± 0.2°).
- C - D: 3.5 mm ± 2 mm (0.14 inch ± 0.08 inch).
If the toe-in is not within the specification, adjust it at the No.2 lower suspension arm.





5. Adjust toe-in.
a. Measure the length of the left and right No.2 lower suspension arms.
No.2 lower suspension arm length difference: 1 mm (0.04 inch) or less.
If the left-right difference is greater than the specification, adjust the length.
b. Loosen the lock nuts.





c. Turn the left and right adjusting tubes an equal amount to adjust toe-in.

HINT:
- Try to adjust the toe-in to the center value.
- One turn of the each adjusting tube will adjust the toe-in about 54' (0.9°, 9 mm, 0.354 inch).

d. Tighten the lock nuts.
Torque: 75 Nm (55 ft. lbs.).