Cylinder Head

Cylinder Head Installation:

TIGHTENING SEQUENCE/SPECIFICATIONS
Install and uniformly tighten the 10 cylinder head bolts and plate washers, in several passes, in the sequence shown.

1st Pass: Torque to 49 Nm (36 ft. lbs.)
^ If any of the cylinder head bolts do not meet the torque specification, replace the cylinder head bolt.





NOTE: Before making 2nd pass, mark the front of the cylinder head bolt head with paint.

2nd Pass: Turn the head bolts an additional 90°.

NOTE: Check that the painted mark is now at a 90° angle to the front.





COMPONENT SPECIFICATIONS
Spark Plug Tube To Cylinder Head: 39 Nm (29 ft. lbs.)
Cover To Head: 44 Nm (33 ft. lbs.)