Idle Up Control Valve: Testing and Inspection
A/C IDLE-UP VALVE INSPECTION1. REMOVE IDLE-UP VALVE.
2. INSPECT IDLE-UP VALVE FOR OPEN CIRCUIT.
- Using an ohmmeter, check that there is continuity between the terminals.
Resistance at 20°C (68°F): 30 - 34 Ohms
- If there is no continuity, replace the idle-up valve.
3. INSPECT IDLE-UP VALVE FOR GROUND.
- Using an ohmmeter, check that there is no continuity between each terminal and the body.
- If there is continuity, replace the idle-up valve.
4. INSPECT IDLE-UP VALVE OPERATION.
- Check that the air does not flow from port E to port F.
- Apply battery voltage across the terminals.
- Check that the air flows from port E to port F.
- If operation is not as specified, replace the idle-up valve.
4. REINSTALL IDLE-UP VALVE.