On-Board Diagnostic System
ELECTRONIC CONTROL SYSTEM
The electronic control system for the A244E automatic transaxle provides extremely precise control of the and shift timing and lock-up timing in response to driving conditions as sensed by various sensors located throughout the vehicle and in response to the engine's running conditions.
At the same time, the Engine Control Module (ECM) control reduces vehicle squat when the vehicle starts out and gear shift shock.
The electronic control system is also equipped with a self diagnoses system which diagnosis malfunctions of electronically controlled components and warns the driver, and a fail-safe which makes it possible for the vehicle to continue functioning when a malfunction occurs. The electronic control system can be broadly divided into three groups; the sensors, ECM and actuators.
DESCRIPTION
1. A self-diagnosis function is built into the electrical control system. Warning is indicated by the overdrive OFF indicator.
HINTS
- Warning and diagnostic trouble codes can be read only when the overdrive switch is ON. If OFF, the overdrive OFF indicator is lit continuously and will not blink.
- If a malfunction occurs within the vehicle speed sensors or solenoids, the overdrive OFF light will blink to warn the driver.
However, there will be no warning of a malfunction with lock-up solenoid.
- The diagnostic trouble code can be read by the number of blinks of the overdrive OFF indicator when terminals TE1 and E1 are short-circuited.
- The throttle position sensor or brake signal are not indicated, but inspection can be made by checking the voltage at terminal TT of the DLC 1.
- The signals to each gear can be checked by measuring the voltage at terminal TT of the DLC 1 while driving.
2. The diagnostic trouble code is retained in memory by the Engine Control Module (ECM) and due to back-up voltage, is not canceled out when the engine is turned off. Consequently, after repair, it is necessary to turn the ignition switch off and remove the EFI fuse (15 A) or disconnect the ECM connector to cancel out the diagnostic trouble code.
HINTS:
- Low battery positive voltage will cause faulty operation of the diagnosis system. Therefore, always check the battery first.
- Use a voltmeter and ohmmeter that have an impedance of at least 10 kohms/volts.