Operation CHARM: Car repair manuals for everyone.

CO/HC Testing Procedures



Note: This check is used only to determine whether or not the idle and/or 2,500 rpm CO/HC emission levels comply with regulations.

1. Initial conditions:

a. Engine at normal operating temperature
b. Air cleaner installed
c. All pipes and hoses of the air induction system connected
d. All accessories switched OFF
e. All vacuum lines properly connected

HINT: All vacuum hoses for Exhaust Gas Recirculation system, etc. should be properly connected.

f. MFI system wiring connectors fully plugged
g. Ignition timing set correctly
h. Transmission in neutral position
i. Tachometer and CO/HC meter calibrated and by hand

2. Start engine.

Emission Check Warm-up Conditions:






3. Race Engine at 2,500 RPM for approx. 180 seconds.

Checking Exhaust Emissions:






4. Insert CO/HC meter testing probe at least 40cm (1.3 ft) into tailpipe during idling.

5. Immediately check CO/HC concentration at idle and/or 2,500 RPM.

HINT: When performing the 2 mode (2,500 rpm and idle) test, follow the measurement order prescribed by the applicable local regulations.

If the CO/HC concentration does not comply with regulations, perform troubleshooting in the following order:

a. Check Oxygen Sensor operation. OE Test Procedure

b. See the table under Failure Diagnosis Chart for possible causes, and then inspect and correct the applicable causes if necessary.

Failure Diagnosis Chart