Federal Vehicles
TWC REPLACEMENT:1. REMOVE ENGINE UNDER COVERS.
2. REMOVE FRONT EXHAUST PIPE.
3. REMOVE FRONT TWC.
- Remove the oxygen sensor from the TWC.
- Remove the 2 bolts, 2 nuts and TWC stay.
- Remove the 3 bolts, 2 nuts, TWC, gasket, retainer and cushion.
- Remove the 8 bolts and 2 heat insulators from the TWC.
4. RE-INSTALL TWC.
- Install the 2 heat insulators to TWC with the 8 bolt.
- Place the cushion, retainer and a new gasket on the TWC.
- Install the TWC with the 3 bolts and 2 nuts.
Torque: 29 Nm (300 kgf/cm, 21 ft.lb)
- Install the TWC stay with the 2 bolts and 2 new nuts.
Torque: 42 Nm (425 kgf/cm, 31 ft.lb)
- Install the oxygen sensor to the TWC.
5. REINSTALL FRONT EXHAUST PIPE.
6. REINSTALL ENGINE UNDER COVERS.