Adjust Ignition Timing

ADJUST IGNITION TIMING
1. Connect a timing light to the engine.
2. Start the engine and run it at idle.




3. Short circuit the terminals of the check connector. T-E1.




4. Using a timing light, slowly turn the distributor until the timing mark on the crankshaft pulley is aligned with the 10° mark. Tighten the distributor bolt. Ignition timing: 10° BTDC@ (T-E1). Torque: 160-220 kg-cm (12 - 15 ft-lb).
5. Unshort the check connector.