Automatic Transmission/Transaxle: Service and Repair
1. Disconnect battery ground cable and drain cooling system.
2. Remove air cleaner and disconnect air intake hose.
3. Disconnect upper radiator hose.
4. Disconnect throttle cable from bracket, guide clips and throttle lever.
5. Raise and support vehicle and drain transmission.
6. Disconnect electrical connectors to back-up lamp and neutral start switches and to solenoids. Connectors are located near starter.
7. Remove driveshaft and center bearing assembly.
8. Disconnect exhaust pipe from rear side of converter, remove 2 rubber hangers and brace to transmission, then separate exhaust pipe from tail pipe.
9. Remove oil cooler line clamp, then disconnect cooler lines, manual linkage and speedometer cable from transmission.
10. Remove front exhaust support, engine and transmission stiffening braces and the torque converter cover.
11. On Supra models, remove steering gear housing as follows:
a. Remove sliding yoke from gear housing.
b. Disconnect tie rod ends from steering knuckles using a suitable puller.
c. Remove mounting bracket bolts, brackets and rubber insulator.
d. Remove gear assembly from crossmember and suspend assembly from crossmember.
12. Support weight of transmission with a suitable jack, disconnect ground strap from rear crossmember and remove crossmember. Position a block of wood between rear of cylinder head and cowl to prevent damage to heater hoses or core fittings.
13. Remove cover from under engine.
14. Remove bolts securing torque converter to drive plate.
15. Fabricate a guide pin by cutting the head from a spare torque converter bolt and install pin in 1 converter bolt hole.
16. Remove starter and position aside.
17. Ensure transmission is properly supported on jack and remove remaining transmission mounting bolts.
18. Pry on torque converter guide pin to separate transmission from engine and remove transmission.
19. Reverse procedure to install.