Operation CHARM: Car repair manuals for everyone.

Assembly

Assembly





1. Installation of swivel
(1) Install the 2 washers, spacer, bushing, and swivel with a snap pin.





2. Installation of gasket
(1) Install 4 spacer plates and the gasket.





3. Installation of select arm bracket
(1) Apply Multemp D to the spring and the rod.
(2) Install the spring and the rod to the select arm bracket.





(3) Apply Multemp D to the select lever COMPL and the select arm bracket.





(4) Apply Multemp D to the sliding surface of the rod and install the select arm bracket to the select lever COMPL.





4. Installation of select lever COMPL
(1) Set the select arm bracket together with the select lever COMPL as a single unit to the base plate.





5. Installation of arm COMPL
(1) Insert the arm COMPL to the base plate.





(2) Use a pin punch 3 and hammer to drive in a new pin.





6. Installation of grommet
(1) Install the grommet.





7. Installation of D rod
(1) Install the bushing D lock.
(2) Install the cushion detent lock to the D rod.
(3) Apply Multemp D to the D lock spring and the D rod.
(4) Install the D lock spring and the D rod.
(5) Install the D lock clamp.
8. Installation of solenoid unit
(1) Apply Multemp D to the solenoid unit and the pin.





(2) Set the solenoid unit together with the shift lock release arm as a unit to the base plate and insert the pin.





9. Installation of guide plate
(1) Engage the 2 claws and install the guide plate to the base plate.





(2) Install the shaft guide pin and a new clamp push nut.





(3) Connect the connectors No.2 and No.3 of the shift lock solenoid connector and the connectors No.10 and No.11 of the manual mode switch connector.

Captions in illustration








(4) Lock the terminal of the harness connector.





(5) Engage the claw and install the connector.