Operation CHARM: Car repair manuals for everyone.

Removal and Replacement

Brake Pedal

REMOVAL

AT MODEL
1) Disconnect the ground cable from the battery.
2) Remove the instrument panel lower cover from instrument panel.
3) Remove the clevis pins which secure the brake pedal to the brake booster operating rod. Also disconnect the stop light switch connector.
4) Remove the two bolts and four nuts which secure brake pedal to pedal.





MT MODEL
1) Remove the steering bolt.
2) Raise the vehicle on a lift and remove the two bolts which secure the steering unit to the underside of the body.
3) Lower the vehicle.
4) Remove the instrument panel lower cover from instrument panel.
5) Disconnect the following parts from pedal bracket.
^ Operating rod of brake booster
^ Connector (stop light switch, etc.)
6) Remove the clevis pin which secures the lever and push rod.
7) Remove the nut which secures the clutch master cylinder.
8) Remove the steering assembly.
9) Remove the accelerator pedal.
10) Remove the bolts and nuts which secure the pedal bracket.





INSTALLATION
1) Install in the reverse order of removal.

CAUTION:
^ If the cable clamp is damaged, replace it with a new part.
^ Never fail to cover outer cable end with boot.
^ Be careful not to twist the accelerator cable.
^ Always use a new clevis pin.


2) Adjust the clutch pedal.
3) Check the brake pedal after installation.